GE RV33-1 Drive Regulation Board
🔷GE RV33-1 is a PROFIBUS-DP Bus Interface Unit that connects a Field Control I/O station to a PROFIBUS I/O bus, handling intelligent processing, I/O scanning and feature configuration for up to eight Field Control I/O modules. It reports faults and diagnostics for itself and its modules, lets the master select input and output defaults, analog scaling and analog ranges, and stores the station configuration in non-volatile memory in its terminal block so the unit can be removed and replaced without rewiring or reconfiguring the station.
🔷Product Datasheet
- Brand: GE
- Model: RV33-1
- Protocol: PROFIBUS-DP
- I/O Capacity: Up to 8 Field Control I/O modules per station
- Rated Input Voltage: 24 V DC
- Input Voltage Range: 18 to 30 V DC
- Input Power: 16.8 W maximum at full load at nominal voltage
- Inrush Current: 15 to 50 A peak, 3 ms maximum
- Output to I/O Modules: 6.5 V DC ±5%, 1.4 A maximum
- Holdup Time: 10 ms maximum from nominal input voltage
- Input Fuse: 1 A, 5 x 20 mm, 250 V AC slow-blow, replaceable
- Bus Connector: 9-pin D-sub
- Hand-Held Programmer Port: Dedicated HHP connector (IC693PRG300 or IC660HHM501)
- Address Setting: DIP switches on the Bus Interface Unit Terminal Block, read at power-up
- Network Topology: Linear bus, terminated at both ends, stubs permissible
- Network Medium: Shielded twisted pair
- Stations per Segment: 32 without repeaters, extendable to 127 with repeaters
- Transmission Speeds: 9.6, 19.2, 93.75, 187.5, 500 and 1500 kbit/s, 3, 6 and 12 Mbit/s
- Status Indicators: Three LEDs
- Mounting: 35 x 7.5 mm DIN rail (conductive, unpainted), terminal block also panel-mountable
- Operating Temperature: 0 to 55 °C
- Storage Temperature: -40 to +85 °C
- Humidity: 5% to 95%, non-condensing
- MTBF: More than 183,000 hours (BIU); more than 600,000 hours (terminal block)
🔷Fault Troubleshooting and Common Questions
- The master does not establish communication with the station. Check the PROFIBUS address set on the terminal block DIP switches, which is read only at power-up, and verify it matches the master’s configuration. Confirm the 9-pin bus connector, cable type, and that the first and last nodes of the segment are terminated.
- The BIU is not powered or keeps restarting. Check the 24 V DC supply within the 18 to 30 V DC range, the replaceable 1 A slow-blow fuse on the input power lines, and the input wiring polarity. Verify that momentary losses do not exceed the 10 ms holdup time, since longer losses reset all I/O modules.
- I/O modules are not scanned or show configuration faults. Verify the modules are seated and that the station was autoconfigured, or configure the modules manually with the Hand-held Programmer. Check the connecting cables between the BIU terminal block and the I/O terminal blocks, and confirm the module types match the stored configuration.
- Can another Field Control BIU replace the RV33-1? Not without verification. The PROFIBUS BIU differs from the Genius BIU in protocol, addressing and master configuration; compare the catalog number, network type, station configuration and terminal block before replacement.
🔷Safety Precautions
- Isolate power and follow lockout/tagout procedures before installing or removing the BIU or its terminal block.
- Use electrostatic discharge protection when handling the BIU and I/O modules.
- Verify the DIN rail is conductive and properly grounded before energizing the station.
- Do not connect field wiring until the input voltage and module ratings have been confirmed.
- Use qualified personnel for installation, network configuration and troubleshooting of the station.

Company Overview
Main Products
We specialize in supplying original imported spare parts for DCS, PLC, robotics, and large servo systems from leading global brands, including:
- FOXBORO | EMERSON | TRICONEX | XYCOM | BENTLY
- ROCKWELL | ABB | GE | Aen-Brady | YOKOGAWA
- HONEYWELL | RELIANCE | SCHNEIDER | MODICO
- Westinghouse | WOODWARD | Motorola | Rexroth | SEW
☀️Tiana Lai(Sales Director)
?Email: ydf8801@163.com
?️Ship to you via DHL/TNT/UPS/EMS/Fedex
?Product Condition: One-year warranty
Contact us immediately to embark on a new experience of efficient procurement! ✨












There are no reviews yet.