REXROTH 0608800048 Straight Output GK2A251 150 Nm
REXROTH 0608800048 is a straight output drive for Rexroth tightening spindles in nominal size 4, with a 1/2″ square tool mount and a working torque range of 15 to 150 Nm. It transfers the spindle’s torque to the socket straight through a 1:1 ratio, incorporates axial compensation along its length, and is built for maintenance-free operation over one million full load cycles in tightening stations.
Product Datasheet
- Brand: Bosch Rexroth
- Model: Straight Output GK2A251 SZ4 1/2″SQ
- Order Number: 0608800048
- Product Family: Tightening spindle output drive, size 4 (SZ4)
- Working Torque Range: 15 to 150 Nm
- Maximum Torque: 150 Nm
- Maximum Drive Speed: 340 min⁻¹
- Tool Mount: 1/2″ square
- Reduction Ratio: 1
- Typical Efficiency: 1
- Length A: 251 mm
- Installation Length: 265 mm
- Weight: 1.0 kg
- Design Features: Axial compensation along the output length; maintenance-free for one million full load cycles
- Category: Tightening technology — tightening spindles — tightening spindle output drives
Fault Troubleshooting and Common Questions
- Measured torque does not match the programmed torque. Check the socket and tool mount engagement, the spindle’s torque calibration, and that the applied torque falls inside the 15 to 150 Nm working range. Inspect the output for wear or damage that would add friction.
- The socket does not seat or wobbles on the output. Verify the tool mount is the 1/2″ square type and that the socket fits without play. Check the square drive and retaining feature for wear, and confirm the socket is rated for the torque being applied.
- The output runs hot, noisy or binds. Check alignment between the spindle and the joint being tightened, verify the axial compensation travel is not bottomed out, and confirm the drive speed does not exceed 340 min⁻¹. Inspect for contamination or damaged bearings.
- Can another Rexroth straight output be used instead? Not without verification. Outputs differ in nominal size, length, tool mount and working range; compare the order number, size code, length designation and tool mount before substitution.
Safety Precautions
- Isolate the spindle drive and follow lockout/tagout procedures before removing or installing the output.
- Use electrostatic discharge protection when handling spindle electronics during service.
- Verify the tool mount, socket rating and torque program before running the station.
- Do not exceed the 150 Nm maximum torque or the 340 min⁻¹ maximum drive speed.
- Use qualified personnel for setup, calibration and maintenance of tightening stations.

Company Overview
Main Products
We specialize in supplying original imported spare parts for DCS, PLC, robotics, and large servo systems from leading global brands, including:
- FOXBORO | EMERSON | TRICONEX | XYCOM | BENTLY
- ROCKWELL | ABB | GE | Aen-Brady | YOKOGAWA
- HONEYWELL | RELIANCE | SCHNEIDER | MODICON
- Westinghouse | WOODWARD | Motorola | Rexroth | SEW
☀️Tiana Lai(Sales Director)
?Email: ydf8801@163.com
?️Ship to you via DHL/TNT/UPS/EMS/Fedex
?Product Condition: One-year warranty
Contact us immediately to embark on a new experience of efficient procurement! ✨












There are no reviews yet.