TRICONEX 4000093-110N External Terminal Input Cable
Brand: Triconex
Model: 4000093-110N
Product Type: External Terminal Input Cable Assembly
Cable Family: 4000093, x10 length variant
Minimum Bend Radius: 5.6 in (14.224 cm)
Function: input signal connection between the I/O module and an external termination panel
In a Tricon chassis, field wiring is normally landed on an external termination panel, an electrically passive printed circuit board mounted in the marshalling or system cabinet. The panel passes input signals from the field to the input module, and the cable assembly is the link between the module connector and that panel, so the module can be taken out or replaced without disturbing any field wiring.
The assembly is supplied factory-terminated with connectors at both ends, which removes field crimping from the installation: the cable is plugged in, the termination panel is wired, and the channel is ready. Correct routing matters more than anything else on this item, because the cable is a passive assembly with no active electronics — a cable routed below its bend radius, or pulled tight around a cabinet edge, damages the shield and the conductors and shows up later as an intermittent channel.
The 4000093 cable family is the group covered in the official Tricon planning and installation guide’s minimum bend radius table, where the 4000093-x10 variant is listed at 5.6 in (14.224 cm). Cables of this series are used on input channels of Tricon safety systems in ESD, fire and gas, burner management and turbine protection cabinets, where the field wiring is terminated in a marshalling panel and the I/O module sits in the controller rack.
![]()
Thương hiệu: Triconex
Mã số: 4000093-110N
Loại sản phẩm: Bộ cáp đầu vào đầu nối ngoài
Dòng cáp: 4000093, biến thể chiều dài x10
Bán kính uốn tối thiểu: 5.6 in (14.224 cm)
Chức năng: truyền tín hiệu đầu vào giữa mô-đun I/O và bảng đấu nối ngoài
Trong tủ Tricon, dây dẫn hiện trường thường được đấu trên bảng đấu nối ngoài — một bảng mạch thụ động về điện gắn trong tủ đấu nối hoặc tủ hệ thống. Bảng này đưa tín hiệu đầu vào từ hiện trường tới mô-đun đầu vào, còn bộ cáp chính là đường nối giữa đầu nối của mô-đun và bảng đó, nhờ vậy có thể tháo hoặc thay mô-đun mà không phải tháo bất kỳ dây hiện trường nào.
Bộ cáp được nhà máy hoàn thiện đầu nối ở cả hai đầu, loại bỏ việc bấm dây tại hiện trường: cắm cáp, đấu dây trên bảng đấu nối là kênh tín hiệu sẵn sàng. Với hạng mục này, việc đi dây đúng quan trọng hơn mọi thông số khác, vì cáp là bộ thụ động không có điện tử tích cực — cáp bị uốn nhỏ hơn bán kính cho phép hoặc bị kéo căng qua cạnh tủ sẽ làm hỏng lớp bọc chống nhiễu và ruột dẫn, và lỗi này sau đó biểu hiện thành hiện tượng chập chờn trên kênh.
Dòng cáp 4000093 là nhóm được nêu trong bảng bán kính uốn tối thiểu của tài liệu quy hoạch và lắp đặt Tricon chính thức, trong đó biến thể 4000093-x10 được ghi là 5.6 in (14.224 cm). Cáp thuộc dòng này được dùng cho các kênh đầu vào của hệ thống an toàn Tricon trong tủ ESD, tủ phát hiện khí và cháy, tủ quản lý đốt và tủ bảo vệ tuabin, nơi dây hiện trường được đấu tập trung tại bảng đấu nối và mô-đun I/O nằm trong khung điều khiển.
Marca: Triconex
Número de Pieza: 2000418
Tipo de Producto: Conjunto de Placa de Comunicación
Nivel de Artículo: Conjunto a nivel de placa
El 2000418 se identifica como un conjunto de comunicación a nivel de placa. Se trata de la placa de circuito impreso utilizada dentro de un producto de comunicación Triconex, no del número de modelo del módulo frontal que aparece en una ranura del chasis, por lo que la identificación y el pedido se realizan por número de conjunto y revisión.
En un sistema instrumentado de seguridad, la placa de comunicación es la parte que transporta el enlace entre el controlador y el exterior: la estación de ingeniería, los maestros y esclavos Modbus y los sistemas host que leen y escriben datos del controlador. La sustitución a nivel de placa se utiliza cuando la circuitería de interfaz está defectuosa y el conjunto mecánico, los conectores y la codificación de ranura siguen siendo utilizables.
Company Overview
Main Products
We specialize in supplying original imported spare parts for DCS, PLC, robotics, and large servo systems from leading global brands, including:
- FOXBORO | EMERSON | TRICONEX | XYCOM | BENTLY
- ROCKWELL | ABB | GE | Aen-Brady | YOKOGAWA
- HONEYWELL | RELIANCE | SCHNEIDER | MODICON
- Westinghouse | WOODWARD | Motorola | Rexroth | SEW
☀️Tiana Lai(Sales Director)
?Email: ydf8801@163.com
?️Ship to you via DHL/TNT/UPS/EMS/Fedex
?Product Condition: One-year warranty
Contact us immediately to embark on a new experience of efficient procurement! ✨












There are no reviews yet.